SciPy

scipy.integrate.complex_ode.get_return_code

complex_ode.get_return_code()[source]

Extracts the return code for the integration to enable better control if the integration fails.

In general, a return code > 0 implies success while a return code < 0 implies failure.

Notes

This section describes possible return codes and their meaning, for available integrators that can be selected by set_integrator method.

“vode”

Return Code Message
2 Integration successful.
-1 Excess work done on this call. (Perhaps wrong MF.)
-2 Excess accuracy requested. (Tolerances too small.)
-3 Illegal input detected. (See printed message.)
-4 Repeated error test failures. (Check all input.)
-5 Repeated convergence failures. (Perhaps bad Jacobian supplied or wrong choice of MF or tolerances.)
-6 Error weight became zero during problem. (Solution component i vanished, and ATOL or ATOL(i) = 0.)

“zvode”

Return Code Message
2 Integration successful.
-1 Excess work done on this call. (Perhaps wrong MF.)
-2 Excess accuracy requested. (Tolerances too small.)
-3 Illegal input detected. (See printed message.)
-4 Repeated error test failures. (Check all input.)
-5 Repeated convergence failures. (Perhaps bad Jacobian supplied or wrong choice of MF or tolerances.)
-6 Error weight became zero during problem. (Solution component i vanished, and ATOL or ATOL(i) = 0.)

“dopri5”

Return Code Message
1 Integration successful.
2 Integration successful (interrupted by solout).
-1 Input is not consistent.
-2 Larger nsteps is needed.
-3 Step size becomes too small.
-4 Problem is probably stiff (interrupted).

“dop853”

Return Code Message
1 Integration successful.
2 Integration successful (interrupted by solout).
-1 Input is not consistent.
-2 Larger nsteps is needed.
-3 Step size becomes too small.
-4 Problem is probably stiff (interrupted).

“lsoda”

Return Code Message
2 Integration successful.
-1 Excess work done on this call (perhaps wrong Dfun type).
-2 Excess accuracy requested (tolerances too small).
-3 Illegal input detected (internal error).
-4 Repeated error test failures (internal error).
-5 Repeated convergence failures (perhaps bad Jacobian or tolerances).
-6 Error weight became zero during problem.
-7 Internal workspace insufficient to finish (internal error).