scipy.ndimage.shift¶
-
scipy.ndimage.
shift
(input, shift, output=None, order=3, mode='constant', cval=0.0, prefilter=True)[source]¶ Shift an array.
The array is shifted using spline interpolation of the requested order. Points outside the boundaries of the input are filled according to the given mode.
Parameters: - input : array_like
The input array.
- shift : float or sequence
The shift along the axes. If a float,
shift
is the same for each axis. If a sequence,shift
should contain one value for each axis.- output : array or dtype, optional
The array in which to place the output, or the dtype of the returned array. By default an array of the same dtype as input will be created.
- order : int, optional
The order of the spline interpolation, default is 3. The order has to be in the range 0-5.
- mode : {‘reflect’, ‘constant’, ‘nearest’, ‘mirror’, ‘wrap’}, optional
The mode parameter determines how the input array is extended beyond its boundaries. Default is ‘constant’. Behavior for each valid value is as follows:
- ‘reflect’ (d c b a | a b c d | d c b a)
The input is extended by reflecting about the edge of the last pixel.
- ‘constant’ (k k k k | a b c d | k k k k)
The input is extended by filling all values beyond the edge with the same constant value, defined by the cval parameter.
- ‘nearest’ (a a a a | a b c d | d d d d)
The input is extended by replicating the last pixel.
- ‘mirror’ (d c b | a b c d | c b a)
The input is extended by reflecting about the center of the last pixel.
- ‘wrap’ (a b c d | a b c d | a b c d)
The input is extended by wrapping around to the opposite edge.
- cval : scalar, optional
Value to fill past edges of input if mode is ‘constant’. Default is 0.0.
- prefilter : bool, optional
Determines if the input array is prefiltered with
spline_filter
before interpolation. The default is True, which will create a temporary float64 array of filtered values if order > 1. If setting this to False, the output will be slightly blurred if order > 1, unless the input is prefiltered, i.e. it is the result of callingspline_filter
on the original input.
Returns: - shift : ndarray
The shifted input.