scipy.integrate.ode.get_return_code¶
-
ode.
get_return_code
()[source]¶ Extracts the return code for the integration to enable better control if the integration fails.
In general, a return code > 0 implies success while a return code < 0 implies failure.
Notes
This section describes possible return codes and their meaning, for available integrators that can be selected by
set_integrator
method.“vode”
Return Code Message 2 Integration successful. -1 Excess work done on this call. (Perhaps wrong MF.) -2 Excess accuracy requested. (Tolerances too small.) -3 Illegal input detected. (See printed message.) -4 Repeated error test failures. (Check all input.) -5 Repeated convergence failures. (Perhaps bad Jacobian supplied or wrong choice of MF or tolerances.) -6 Error weight became zero during problem. (Solution component i vanished, and ATOL or ATOL(i) = 0.) “zvode”
Return Code Message 2 Integration successful. -1 Excess work done on this call. (Perhaps wrong MF.) -2 Excess accuracy requested. (Tolerances too small.) -3 Illegal input detected. (See printed message.) -4 Repeated error test failures. (Check all input.) -5 Repeated convergence failures. (Perhaps bad Jacobian supplied or wrong choice of MF or tolerances.) -6 Error weight became zero during problem. (Solution component i vanished, and ATOL or ATOL(i) = 0.) “dopri5”
Return Code Message 1 Integration successful. 2 Integration successful (interrupted by solout). -1 Input is not consistent. -2 Larger nsteps is needed. -3 Step size becomes too small. -4 Problem is probably stiff (interrupted). “dop853”
Return Code Message 1 Integration successful. 2 Integration successful (interrupted by solout). -1 Input is not consistent. -2 Larger nsteps is needed. -3 Step size becomes too small. -4 Problem is probably stiff (interrupted). “lsoda”
Return Code Message 2 Integration successful. -1 Excess work done on this call (perhaps wrong Dfun type). -2 Excess accuracy requested (tolerances too small). -3 Illegal input detected (internal error). -4 Repeated error test failures (internal error). -5 Repeated convergence failures (perhaps bad Jacobian or tolerances). -6 Error weight became zero during problem. -7 Internal workspace insufficient to finish (internal error).